Alsat V-Box 500 GBOX v3000 DiSEqC Positioner

Alsat V-Box 500 GBOX v3000
 

This controller is used to position your C band dish. It takes DiSEqC commands from your satellite receiver and converts it into 36V pulse and sensor to store positions - can store 99 Positions. It can work as a stand alone positioner or it can accept DiSEqC 1.2 commands from a satellite receiver. Controls and displays position. Remote control Included.

Simply loop the LNB cable in and connect the motor control wires. Once connected and installed the unit can be forgotten as only the satellite receiver's remote is then required. Compatible with DiSEQc 1.2 Receivers. 99 Programmable memories. Easy operation and quick installation. Fine-tune Function for better reception. Anti-noise circuit to avoid miscounting. Short circuit and overload protection. Software limits protection. Re-synchronize function. 180 degree H to H mount compatible. Straight linear actuator / polar mount compatible. 220-240 volt AC 50 Hz. Output voltages 13/18 volt (F type) 36 volts on motor cable. Supplied with Remote Control. Dimensions 239 by 58 by 148 mm

FEATURES: -

• Compatible with All DiSEqC 1.2 Receiver
• Compatible with All Kinds of Actuator and H-H Mount
• (Reed Switch Sensor)
• 99 Easily Programmed Position
• 60 Pre-stored Satellite Names & 30 Free Names at User's Choice
• 6 Digit LED Display
• 23 Keys Full Function IR Remote Control Included
• Fine-tune EAST / WEST Buttons for Better Reception
• Recall Satellite Positions by 3 Control Buttons on Front Panel
• Wrong Wiring and Short Circuit Protection
• Re-synchronizing Function

SPECIFICATION